PLUG-IN CHARGE CONTROL SYSTEM, Diagnostic DTC:P0D4C12, P0D4C14

DTC Code DTC Name
P0D4C12 Hybrid/EV Battery Charger Hybrid/EV Battery Input Voltage Sensor Circuit Short to Auxiliary Battery
P0D4C14 Hybrid/EV Battery Charger Hybrid/EV Battery Input Voltage Sensor Circuit Short to Ground or Open

DESCRIPTION

The charge control ECU built into the electric vehicle charger assembly monitors the direct current voltage using the VCHG sensor. If it detects a VCHG sensor malfunction, it stores a DTC. If these DTCs are output, replace the electric vehicle charger assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P0D4C12 Hybrid/EV Battery Charger Hybrid/EV Battery Input Voltage Sensor Circuit Short to Auxiliary Battery

VCHG sensor output is below the threshold.

(1 trip detection logic)

 Electric vehicle charger assembly Comes on

Master Warning Light:

Comes on
P0D4C14 Hybrid/EV Battery Charger Hybrid/EV Battery Input Voltage Sensor Circuit Short to Ground or Open

VCHG sensor output is above the threshold.

(1 trip detection logic)

 Electric vehicle charger assembly Comes on

Master Warning Light:

Comes on

CONFIRMATION DRIVING PATTERN

Tech Tips

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click here


  1. Connect the GTS to the DLC3.

  2. Turn the power switch on (IG) and turn the GTS on.

  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

  4. Enter the following menus: Powertrain / Hybrid Control / Data List.

  5. Check that "Hybrid Battery SOC" shows 70% or less.

  6. Turn the power switch off and wait for 2 minutes or more.

  7. Connect the electric vehicle charger cable assembly, plug-in charge the vehicle for 30 seconds or more.

  8. Disconnect the electric vehicle charger cable assembly and wait for 10 seconds or more.

  9. Turn the power switch on (IG) and turn the GTS on.

  10. Enter the following menus: Powertrain / Plug-in Control / Utility / All Readiness.

  11. Check the DTC judgment result.

    Tech Tips


    • If the judgment result shows NORMAL, the system is normal.

    • If the judgment result shows ABNORMAL, the system has a malfunction.

    • If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.

PROCEDURE


  1. REPLACE ELECTRIC VEHICLE CHARGER ASSEMBLY

    Click here

    Result
    Proceed to
    NEXT

    NEXT

    COMPLETED