HYBRID CONTROL SYSTEM, Diagnostic DTC:P33BF9F

DTC Code DTC Name
P33BF9F Motor/Generator Shutdown Signal (MG Side) Stuck Off

DTC SUMMARY


  1. MALFUNCTION DESCRIPTION

    The hybrid vehicle control ECU detects malfunctions which prevent the inverter with converter assembly emergency shutdown circuit (HSDN) from shutting down the hybrid control system. Detection is performed when the power switch is turned on (IG) and during the shutdown sequence when the power switch is turned off. If any of the following condition is detected, this DTC will be stored. If the following conditions are not detected, DTC P321E9F will be stored.


    • Inverter with converter assembly malfunction

DESCRIPTION

Refer to the description for DTC P321E9F.

Click here

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P33BF9F Motor/Generator Shutdown Signal (MG Side) Stuck Off

When the HV gate block function check is performed (when the power switch is turned from on (READY) to off), the HSDN (MG shutdown) signal sent from the hybrid vehicle control ECU is received by the motor generator control ECU (MG ECU) but the inverter current and voltage (VH) do not decrease.

(1 trip detection logic)

 Inverter with converter assembly Does not come on

Master Warning Light:

Comes on
Related Data List
DTC No. Data List
P33BF9F

  • Ready Signal

  • Inverter Emergency Shutdown (Main CPU)

  • Inverter Emergency Shutdown (Sub CPU)

CONFIRMATION DRIVING PATTERN

Tech Tips

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click here


  1. Connect the GTS to the DLC3.

  2. Turn the power switch on (IG) and turn the GTS on.

  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

  4. Turn the power switch off and wait for 2 minutes or more.

  5. Turn the power switch on (READY) and wait for 30 seconds or more.

  6. Turn the power switch off and wait for 2 minutes or more.

  7. Turn the power switch on (READY) and wait for 30 seconds or more.

  8. Turn the power switch off and wait for 2 minutes or more.

  9. Turn the power switch on (IG) and turn the GTS on.

  10. Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.

  11. Check the DTC judgment result.

    Tech Tips


    • If the judgment result shows NORMAL, the system is normal.

    • If the judgment result shows ABNORMAL, the system has a malfunction.

    • If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.

PROCEDURE


  1. REFER TO REPLACE INVERTER WITH CONVERTER ASSEMBLY PARTS

    Click here

    Result
    Proceed to
    NEXT

    NEXT

    END