KNOCK SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

    for SFI system (w/ Canister Pump Module)

  • Replacement of throttle body assembly

  • Cleaning the deposits from the throttle body assembly

  • Replacement of knock control sensor

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here


    for SFI system (w/o Canister Pump Module)

  • Replacement of throttle body assembly

  • Cleaning the deposits from the throttle body assembly

  • Replacement of knock control sensor

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE INTAKE MANIFOLD

    Click here

  2. REMOVE KNOCK CONTROL SENSOR


    1. A003MEK

      Disconnect the knock control sensor connector.

    2. Remove the bolt and knock control sensor from the cylinder block sub-assembly.

      Note

      If the knock control sensor has been struck or dropped, replace it.