CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

1. INSTALL CRANKSHAFT POSITION SENSOR

   
   

   1. Apply a light coat of engine oil to the O-ring.

      Note

      If reusing the crankshaft position sensor, check the O-ring.

   2. Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      
      

      • Make sure that the O-ring is not cracked or moved out of place when installing crankshaft position sensor.

      • If the crankshaft position sensor has been struck or dropped, replace it.

   3. Connect the crankshaft position sensor connector.

2. INSPECT FOR OIL LEAK

   Click here