BLACK OUT TAPE(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door lower outside stripe, rear door outside stripe and rear door upper outside stripe removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link

  • Rear door glass

  • Rear door glass run

 Initialize power window control system

  • Auto up and down function

  • Jam protection function

  • Remote control function

  • Key-linked function

  • Wireless transmitter-linked function

  • Key-off operation function

  • Catch protection function

  • Window open warning function

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR DOOR BELT MOULDING ASSEMBLY

    Click here

  2. REMOVE REAR SPEAKER ASSEMBLY

    Click here

  3. REMOVE REAR DOOR FRAME GARNISH

    Click here

  4. REMOVE REAR DOOR CHECK ASSEMBLY

    Click here

  5. REMOVE REAR DOOR WEATHERSTRIP

    Click here

  6. REMOVE REAR DOOR WINDOW FRAME FRONT MOULDING

    Click here

  7. REMOVE REAR DOOR WINDOW FRAME UPPER MOULDING

    Click here

  8. REMOVE REAR DOOR WINDOW FRAME REAR MOULDING

    Click here

  9. REMOVE REAR DOOR LOWER OUTSIDE STRIPE


    1. Using an infrared light, heat the rear door lower outside stripe.

      Heating Temperature
      Item Temperature
      Rear Door Lower Outside Stripe 40 to 60°C (104 to 140°F) 3 to 5 minutes

      CAUTION:

      A01MIK5C12
      *a Heated Part
      *b Infrared Light

      • Do not touch the infrared light and heated parts.

      • Touching the infrared light may result in burns.

      • Touching heated parts for a long time may result in burns.

    2. A01MH7N

      Pull back on one of the ends of the rear door lower outside stripe to remove it.

  10. REMOVE REAR DOOR OUTSIDE STRIPE


    1. Using an infrared light, heat the rear door outside stripe.

      Heating Temperature
      Item Temperature
      Rear Door Outside Stripe 40 to 60°C (104 to 140°F) 3 to 5 minutes

      CAUTION:

      A01MIK5C12
      *a Heated Part
      *b Infrared Light

      • Do not touch the infrared light and heated parts.

      • Touching the infrared light may result in burns.

      • Touching heated parts for a long time may result in burns.

    2. A01MG9P

      Pull back on one of the ends of the rear door outside stripe to remove it.

  11. REMOVE REAR DOOR UPPER OUTSIDE STRIPE


    1. Using an infrared light, heat the rear door upper outside stripe.

      Heating Temperature
      Item Temperature
      Rear Door Upper Outside Stripe 40 to 60°C (104 to 140°F) 3 to 5 minutes

      CAUTION:

      A01MIK5C12
      *a Heated Part
      *b Infrared Light

      • Do not touch the infrared light and heated parts.

      • Touching the infrared light may result in burns.

      • Touching heated parts for a long time may result in burns.

    2. A01MFY0

      Pull back on one of the ends of the rear door upper outside stripe to remove it.