FRONT PILLAR UPPER COVER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT FENDER TOP REINFORCEMENT SUB-ASSEMBLY


    1. A01MH49N01

      Using a clip remover, disengage the clip A.

    2. Using a moulding remover B, disengage the clips in the order shown in the illustration.

    3. A01MJAIC01
      B006JFV Remove in this Direction (1)
      B006JHL Remove in this Direction (2)

      Disengage the guides to remove the front fender top reinforcement sub-assembly as shown in the illustration.

  2. REMOVE FRONT PILLAR UPPER COVER SUB-ASSEMBLY


    1. A01MJUNC01
      B000ZUW Protective Tape

      Apply protective tape around the front pillar upper cover sub-assembly.

    2. A01MIPD

      Remove the 4 screws.

    3. A01MFZRC01
      B006JDZ Place Hands Here
      B006JFV Remove in this Direction

      Disengage the clips to remove the front pillar upper cover sub-assembly as shown in the illustration.

      Note

      Disengage the clips from the front to the rear ofthe vehicle. When the clips cannot be disengaged from the vehicle in the ordinary process, push them out from the inside of the vehicle.