ROOF DRIP SIDE FINISH MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP

    Note

    When installing new roof drip side finish moulding clips, remove the double-sided tape remaining where the roof drip side finish moulding clips will be installed on the vehicle body and clean the vehicle body with non-residue solvent.


    1. A01MI37

      Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to 2 new roof drip side finish moulding clips.

      Tech Tips

      Adhesive strength (tensile strength): 13.7 MPa (140.0 kgf/cm2, 1987 psi) or more (when the temperature is 23°C (73°F).)

    2. A01MJ5JN01

      Install the roof drip side finish moulding clips to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the 2 roof drip side finish moulding clips after lightly applying adhesive (3M DP-105 or equivalent).

      Standard Dimension
      Dimension Measurement
      A 1.5 mm (0.059 in.)
      B 3.5 mm (0.138 in.)
      C 3.0 mm (0.118 in.)
      D 3.0 mm (0.118 in.)
      E 1.4 mm (0.055 in.)
      F 1.7 mm (0.067 in.)
      G 3.0 mm (0.118 in.)
      H 3.0 mm (0.118 in.)

    3. Install the center roof drip side finish moulding when 20 minutes or more have elapsed after pressing and installing the 2 roof drip side finish moulding clips.

      Tech Tips


      • Initial hardening time: 20 minutes

      • Complete hardening time: 48 hours

  2. INSTALL CENTER ROOF DRIP SIDE FINISH MOULDING


    1. Engage the roof drip side moulding clips to install the center roof drip side finish moulding.

    2. Remove the protective tape.