WINDSHIELD OUTSIDE MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL NO. 2 WINDSHIELD OUTSIDE MOULDING CLIP


    1. A01MG60

      Temporarily install the No. 2 windshield outside moulding clip to the body.

    2. Using an air riveter or hand riveter with a nose piece, install the rear door window frame rear moulding with 2 new rivets.

      Tech Tips

      If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

      Note


      • A01MIQXC23
        *a Riveter
        *b Mandrel
        *c Incorrect

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

      • A01MITLC21
        *a Riveter
        *b Incorrect

        Confirm that the rivets are seated properly against the moulding.

      • Do not tilt the riveter when installing the rivet to the moulding.

      • Do not leave any space between the rivet head and moulding.

      • A01MJNYC19
        *a Riveter
        *b Incorrect

        Do not leave any space between the moulding and door frame. Firmly hold the 2 items together while installing the rivet.

  2. INSTALL FRONT PILLAR OUTER GARNISH


    1. A01MGQ8C01
      B006JFV Install in this Direction (1)
      B006JHL Install in this Direction (2)

      Engage the guide, clips and claws to install the front pillar outer garnish as shown in the illustration.

      Note

      If the front pillar garnish outer LH contacts the body, it could be damaged.

    2. Using a hexagon socket wrench 4, install the screw.

    3. Remove the protective tape.

  3. INSTALL FRONT PILLAR UPPER COVER SUB-ASSEMBLY

    Click here