FRONT DOOR WINDOW FRAME MOULDING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front door belt moulding assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link

  • Front door glass

  • Front door grass run

 Initialize power window control system

  • Auto up and down function

  • Jam protection function

  • Remote control function

  • Key-linked function

  • Wireless transmitter-linked function

  • Catch protection function

  • Window open warning function

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY

    Click here

  2. REMOVE DOOR FRAME GARNISH

    Click here

  3. REMOVE FRONT DOOR CHECK ASSEMBLY

    Click here

  4. REMOVE FRONT DOOR WEATHERSTRIP

    Click here

  5. REMOVE FRONT DOOR WINDOW FRAME REAR MOULDING


    1. Using an infrared light, heat the front door window frame rear moulding.

      Heating Temperature
      Item Temperature
      Front Door Window Frame Rear Moulding 40 to 60°C (104 to 140°F) 3 to 5 minutes

      CAUTION:

      A01MIK5C12
      *a Heated Part
      *b Infrared Light

      • Do not touch the infrared light and heated parts.

      • Touching the infrared light may result in burns.

      • Touching heated parts for a long time may result in burns.

    2. Using a moulding remover D, disengage the clip and guide to remove the front door window frame rear moulding as shown in the illustration.

      A01MGCEC02
      *a Double-sided Tape *b Caulking Sponge with Butyl Layer
      B006JFV Remove in this Direction (1) B006JHL Remove in this Direction (2)

  6. REMOVE FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY


    1. Insert a 4.0 mm (0.157 in.) drill bit into a drill.

    2. Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.

      A01MFTSC02
      *a 5.0 mm (0.197 in.) - -

      Tech Tips

      Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

    3. Lightly press the drill against the rivets to drill off the rivet flanges, and remove the 7 rivets.

      Note


      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

      • Prying the rivets with the drill may damage the rivet installation holes or drill bit.

      • Be careful of the drilled rivets, as they may be hot.

    4. Remove the rear end cover and front door outside moulding sub-assembly.