ROCKER PANEL MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL HOUSE FRONT PLATE

    Click here

  2. REMOVE NO. 2 MOTOR UNDER COVER

    Click here

  3. REMOVE FRONT FLOOR COVER LH

    Click here

  4. REMOVE FRONT FLOOR COVER RH

    Click here

  5. REMOVE ROCKER PANEL MOULDING COVER (for Rear Side)


    1. A01MIDYC02
      *a Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, disengage the claws to remove the rocker panel moulding cover.

      Tech Tips

      Use the same procedure for the front and rear sides.

  6. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY


    1. Apply protective tape around the body rocker panel moulding assembly.

      A01MJY2C02
      B000ZUW Protective Tape - -
    2. A01MHD1

      Remove the screw.

    3. Using a hexagon socket wrench 4, remove the 2 screws.

    4. A01MJ0B

      Remove the grommet.

    5. A01MHNU

      Using a hexagon socket wrench 4, remove the screw.

    6. A01MJDC

      Remove the screw.

      Tech Tips

      Use the same procedure for the front and rear sides.

    7. Remove the 8 clips.

      A01MHLZ

    8. Disengage the clips to remove the body rocker panel moulding assembly.

      A01MJJH