REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY


    1. Engage the claws to install the rear door belt moulding assembly as shown in the illustration.

      A01MHYEC02
      B006JFV Install in this Direction - -

    2. Remove the protective tape.

  2. INSTALL REAR DOOR REAR GUIDE SEAL

    Click here

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  4. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  5. INSTALL REAR DOOR GLASS RUN

    Click here

  6. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  7. INSTALL REAR DOOR GLASS INNER WEATHERSTRIP

    Click here

  8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  10. INSTALL NO. 1 REAR DOOR STIFFENER CUSHION

    Click here

  11. INSTALL REAR DOOR ARMREST COVER

    Click here

  12. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  13. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  14. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  15. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  16. INSPECT POWER WINDOW OPERATION

    Click here