REAR BUMPER INSTALLATION

PROCEDURE


  1. INSTALL REAR BUMPER ASSEMBLY


    1. A01MJGPC02
      B006JFV Install in this Direction

      Set the rear bumper assembly on the vehicle.

      Note

      Do not fully install the rear bumper assembly onto the vehicle.

    2. A01MG0I

      Connect the connector.

    3. A01MFKPC02
      B006JFV Install in this Direction

      Engage the claws as shown in the illustration.

    4. A01MINRC02
      B006JFV Install in this Direction

      Align the positions of the claws on the rear bumper assembly and rear bumper side support LH, and press the rear bumper assembly as shown in the illustration to engage the claws.

      Tech Tips

      Use the same procedure for the RH side.

    5. A01MK0XC02
      B006JFV Install in this Direction

      Align the positions of the claws on the rear bumper assembly and rear bumper side retainer LH, and press the rear bumper assembly as shown in the illustration to engage the claws.

      Tech Tips

      Use the same procedure for the RH side.

    6. Install the 4 screws and 2 clips.

    7. Install the screw.

      Tech Tips

      Use the same procedure for the RH side.

    8. Install the 2 screws.

    9. Remove the protective tape.

  2. INSTALL REAR BUMPER SIDE SEAL LH


    1. A01MG7Z

      Engage the claw to install the rear bumper side seal LH.

    2. Install the 6 clips.

  3. INSTALL REAR BUMPER SIDE SEAL RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. INSTALL NO. 1 REAR BUMPER PLATE


    1. A01MG0A

      Engage the hook.

    2. Engage the claws to install the No. 1 rear bumper plate.

      Tech Tips

      Use the same procedure for the RH side.