STOP LIGHT SWITCH ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT STOP LIGHT SWITCH ASSEMBLY


    1. A01MH8HC24
      *a

      Front view of wire harness connector

      (Stop Light Switch Assembly)

      Disconnect the stop light switch assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A17-7 (B) - A17-2 (GND) Power switch off 11 to 14 V

    3. Measure the voltage according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A17-2 (GND) - Body ground Always Below 1 Ω
    4. A01MGJ1C17
      *a

      Component with harness connected

      (Stop Light Switch Assembly)

      Connect the stop light switch assembly connector.

    5. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A17-1 (OUT) - A17-2 (GND) Power switch off, brake pedal not depressed Below 1 V
      A17-1 (OUT) - A17-2 (GND) Power switch off, brake pedal depressed 11 to 14 V
      A17-3 (L) - A17-2 (GND) Power switch off, brake pedal not depressed Below 1 V
      A17-3 (L) - A17-2 (GND) Power switch off, brake pedal depressed 11 to 14 V
      A17-4 (ACC) - A17-2 (GND) Power switch off 11 to 14 V