REAR COMBINATION LIGHT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR COMBINATION LIGHT ASSEMBLY


    1. A01MGMV

      Pass the connector and grommet through the hole on the luggage compartment trim cover assembly into the cabin.

    2. A01MIMQ

      Fold back a part of the edge of the luggage compartment trim cover assembly and engage the grommet.

    3. Connect the connector.

    4. A01MIU5C02
      *a Pin
      *b Guide
      B006JFV Install in this Direction

      Engage the guide and pins.

    5. Install the rear combination light assembly with the 4 screws.

    6. A01MIQJ

      Install the 2 clips.

    7. Engage the claws to install the rope hook.

    8. Install the luggage compartment door weatherstrip.

    9. Remove the protective tape.

  2. INSTALL REAR COMBINATION LIGHT COVER


    1. A01MG79C02
      B006JFV Install in this Direction

      Engage the claws to install the rear combination light cover as shown in the illustration.

  3. INSTALL REAR BUMPER ASSEMBLY

    Click here