REAR COMBINATION LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE REAR COMBINATION LIGHT COVER


    1. A01MJBQC02
      B006JDZ Place Hands Here
      B006JFV Remove in this Direction

      Using a moulding remover A, disengage the claws to remove the rear combination light cover as shown in the illustration.

  3. REMOVE REAR COMBINATION LIGHT ASSEMBLY


    1. A01MJISC02
      B000ZUW Protective Tape

      Apply protective tape around the rear combination light assembly as shown in the illustration.

    2. A01MJ62

      Remove the 4 screws.

    3. A01MGGJC02
      *a Protective Tape
      *b Pin
      *c Guide
      B006JDZ Place Hands Here
      B006JFV Remove in this Direction

      Apply protective tape to the rear combination light assembly as shown in the illustration.

    4. As shown in the illustration, hold the protective tape, pull it towards the rear of the vehicle and disengage the pins and the guide to remove the rear combination light assembly.

      Note

      Because the connector and grommet are connected, complete removal is not possible.

    5. Remove the protective tape.

    6. A01MJZRC02
      B006JEG Push

      Disengage the claws to remove the rope hook.

    7. Using a clip remover, remove the 2 clips.

    8. Separate the luggage compartment door weatherstrip as shown in the illustration.

    9. A01MFPJ

      Fold back a part of the edge of part of the luggage compartment trim cover assembly, and disconnect the connector.

    10. A01MG9OC02
      B006JDZ Place Hands Here
      B006JFV Remove in this Direction

      Disengage the grommet, and push it through the hole on the luggage component trim cover assembly toward the outside of the vehicle.