HEADLIGHT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL HEADLIGHT ASSEMBLY


    1. Connect the connector and lock the connector lock lever as shown in the illustration.

      Note

      When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other parts.

      A01MFV0C02
      B006JFV Install in this Direction (1) B006JHL Install in this Direction (2)
      A01MG0O Install in this Direction (3) - -

    2. Install the headlight assembly with the 3 screws.

    3. Install the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    4. Remove the protective tape.

  2. INSTALL RADIATOR GRILLE BRACKET

    Click here

  3. INSTALL FRONT PILLAR UPPER COVER SUB-ASSEMBLY

    Click here

  4. INSTALL FRONT FENDER TOP REINFORCEMENT SUB-ASSEMBLY

    Click here

  5. INSTALL FRONT BUMPER ASSEMBLY

    Click here

  6. PERFORM INITIALIZATION (When Replacing The Headlight Assembly LH or Headlight Light Control ECU Sub-assembly LH)

    Note

    If any of the work in the table below has been performed, vehicle information registration and initialization of the headlight light control ECU sub-assembly LH is necessary.

    Performed Work or System Condition Necessary Procedures
    Replacement of the headlight light control ECU sub-assembly LH Vehicle information registration for the headlight light control ECU sub-assembly LH
    Initialization of the headlight light control ECU sub-assembly LH
    Replacement of the headlight assembly LH Vehicle information registration for the headlight light control ECU sub-assembly LH
    Initialization of the headlight light control ECU sub-assembly LH

    A new headlight light control ECU sub-assembly LH cannot operate until the vehicle information is registered.

    After replacing the headlight light control ECU sub-assembly LH, it is necessary to register the vehicle information and then perform initialization.

    Even if the headlight light control ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.

    Vehicle information registration must be performed with the multiplex network body ECU (main body ECU) and hybrid vehicle control ECU connected via CAN communication.

  7. ADJUST HEADLIGHT AIMING

    Click here