WASHER NOZZLE ON-VEHICLE INSPECTION

PROCEDURE


  1. INSTALL WASHER NOZZLE SUB-ASSEMBLY (for LHD)


    1. Operate the washer nozzle sub-assembly and check the position that the washer fluid hits the windshield.

      Standard
      Washer fluid hits the windshield in the areas shown in the illustration.
      A01MISCC01
      *a Upper Limit *b Standard
      *c Lower Limit *d Vehicle center line
      B000ZUW Measurement - -
      Standard
      Area Measurement Area Measurement
      A 472.0 mm (18.58 in.) B 199.0 mm (7.83 in.)
      C 102.9 mm (4.05 in.) - -

      Note

      If the result is not as specified, replace the washer nozzle sub-assembly.

  2. INSPECT WASHER NOZZLE SUB-ASSEMBLY (for RHD)


    1. Operate the washer nozzle sub-assembly and check the position that the washer fluid hits the windshield.

      Standard
      Washer fluid hits the windshield in the areas shown in the illustration.
      A01MJ9QC03
      *a Upper Limit *b Standard
      *c Lower Limit *d Vehicle center line
      B000ZUW Measurement - -
      Standard
      Area Measurement Area Measurement
      A 472.0 mm (18.58 in.) B 199.0 mm (7.83 in.)
      C 102.9 mm (4.05 in.) - -

      Note

      If the result is not as specified, replace the washer nozzle sub-assembly.