OUTER REAR VIEW MIRROR GLASS INSPECTION

PROCEDURE


  1. INSPECT OUTER MIRROR LH


    1. A01MGIBC02
      *a

      Component without harness connected

      (Outer Mirror LH)

      Check the outer mirror heater operation.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 8.5 to 11.5 Ω

        If the result is not as specified, replace the outer mirror LH.

    2. Check the operation of the outer rear view mirror indicator. (w/ Blind Spot Monitor)


      1. A01MHDJC03
        *a

        Component without harness connected

        (Outer Mirror LH)

        Apply 6 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on.

        Note

        Do not apply a voltage of more than 6 V.

        Tech Tips

        Connect 4 new 1.5 V dry-cell batteries in series.

        OK
        Tester Connection Specified Condition

        6 V battery positive (+) → 2 (BSM+)

        6 V battery negative (-) → 1 (BSM-)

        		 Outer rear view mirror indicator comes on

        If the result is not as specified, replace the outer mirror LH.

  2. INSPECT OUTER MIRROR RH


    1. A01MGRPC02
      *a

      Component without harness connected

      (Outer Mirror RH)

      Check the outer mirror heater operation.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 8.5 to 11.5 Ω

        If the result is not as specified, replace the outer mirror RH.

    2. Check the operation of the outer rear view mirror indicator. (w/ Blind Spot Monitor)


      1. A01MHDJC02
        *a

        Component without harness connected

        (Outer Mirror RH)

        Apply 6 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on.

        Note

        Do not apply a voltage of more than 6 V.

        Tech Tips

        Connect 4 new 1.5 V dry-cell batteries in series.

        OK
        Tester Connection Specified Condition

        6 V battery positive (+) → 2 (BSM+)

        6 V battery negative (-) → 1 (BSM-)

        		 Outer rear view mirror indicator comes on

        If the result is not as specified, replace the outer mirror RH.