HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY


    1. A01MJT7

      Tie the string that was passed thorough the motor compartment room to the end of the hood lock control cable assembly as shown in the illustration.

    2. Pass the hood lock control cable assembly into the motor compartment.

    3. Engage the hood cable grommet.

      A01MG0MC03
      *1 Hood Lock Control Cable Assembly *2 Clamp
      *3 Hood Cable Grommet *4 Wiring Harness Protector

    4. Engage the wiring harness protector.

    5. Engage the hood lock control cable assembly to the clamps.

    6. Remove the string from the hood lock control cable assembly.

  2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.

  3. INSTALL HOOD LOCK ASSEMBLY

    Click here

  4. INSPECT HOOD SUB-ASSEMBLY

    Click here

  5. ADJUST HOOD SUB-ASSEMBLY

    Click here

  6. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  7. INSTALL FRONT FENDER TOP REINFORCEMENT SUB-ASSEMBLY RH

    Click here

  8. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

    Click here

  9. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

    Click here

  10. INSTALL TIRE AND WHEEL

    Click here

  11. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL

    Click here