HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD) REMOVAL

PROCEDURE


  1. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL

    Click here

  2. REMOVE TIRE AND WHEEL

    Click here

  3. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

    Click here

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

    Click here

  5. REMOVE FRONT FENDER TOP REINFORCEMENT SUB-ASSEMBLY RH

    Click here

  6. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  7. REMOVE HOOD LOCK ASSEMBLY

    Click here

  8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A01MIL3

      Disconnect the hood lock control cabel assembly to remove the hood lock control lever sub-assembly.

  9. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


    1. A01MJT7

      Tie a string to the end of the hood lock control cable assembly.

      Tech Tips

      Using a length of string long enough to pass through the motor compartment.

    2. Using a screwdriver with its tip wrapped in protective tape, disengage the clamps, wiring harness protector and hood cable grommet as shown in the illustration.

      A01MG0MC03
      *1 Hood Lock Control Cable Assembly *2 Clamp
      *3 Hood Cable Grommet *4 Wiring Harness Protector

    3. Pull the hood lock control cable assembly from the motor compartment to remove it.

    4. Remove the string from the hood lock control cable assembly.