HOOD SUPPORT REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE HOOD SUPPORT ASSEMBLY

    CAUTION:


    • A01MJP2

      Do not perform work if the vehicle hood is not securely supported.

    • The hood could fall, resulting in injury.

    Note


    • Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

    • Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

    • Do not push sideways on the cylinder because the rod may bend.


    1. A01MIVNC01
      *a Protective Tape

      Using a thin-bladed screwdriver with its tip wrapped in protective tape, remove the 2 stop rings along their grooves.

      Tech Tips

      Tape the thin-bladed screwdriver tip before use.

    2. Disengage the 2 ball joints to remove the hood support assembly.

      Note

      Remove the hood support assembly while holding the hood by hand.

  2. REMOVE HOOD STAY BRACKET


    1. A01MG30

      Remove the bolt.

    2. Disengage the guide to remove the hood stay bracket.