LUGGAGE COMPARTMENT DOOR ADJUSTMENT

PROCEDURE

1. INSPECT LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY

   
   

   1. Check that the clearance measurements of areas "A" through "G" are within each standard range.

      

      Standard Clearance
      Area Measurement Area Measurement A 8.5 mm (0.335 in.) B 3.8 mm (0.150 in.) C 0 mm (0 in.) D 3.1 to 6.1 mm (0.122 to 0.240 in.) E 2.5 to 5.5 mm (0.098 to 0.217 in.) F 4.0 to 8.0 mm (0.157 to 0.315 in.) G 4.0 to 8.0 mm (0.157 to 0.315 in.) - -

2. REMOVE LUGGAGE COMPARTMENT DOOR COVER

   Click here

3. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH

   Click here

4. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH

   Tech Tips

   Use the same procedure described for the RH side.

5. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

   Click here

6. REMOVE REAR FLOOR FINISH PLATE

   Click here

7. ADJUST LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY

   
   

   1. 

      Loosen the hinge bolts to adjust the door horizontally and vertically.

   2. Tighten the hinge bolts after adjustment.

      Torque:

      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

   3. 

      Loosen the striker mounting bolts.

   4. Using a brass bar and a hammer, hit the striker to adjust its position.

   5. Tighten the striker mounting bolts after adjustment.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

8. INSTALL REAR FLOOR FINISH PLATE

   Click here

9. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

   Click here

10. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER RH

    Click here

11. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER LH

    Tech Tips

    Use the same procedure described for the RH side.

12. INSTALL LUGGAGE COMPARTMENT DOOR COVER

    Click here