POWER WINDOW REGULATOR MOTOR(for Rear Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH side.

  • The procedure described below is for the LH side.

PROCEDURE


  1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with 3 "TORX" screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

      Tech Tips

      A new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

    Click here

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  4. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  5. INSTALL REAR DOOR GLASS RUN

    Click here

  6. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  7. INSTALL REAR DOOR GLASS INNER WEATHERSTRIP

    Click here

  8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  10. INSTALL NO. 1 REAR DOOR STIFFENER CUSHION

    Click here

  11. INSTALL REAR DOOR ARMREST COVER

    Click here

  12. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  13. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  14. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  15. INITIALIZE POWER WINDOW SYSTEM

    Click here

  16. INSPECT POWER WINDOW OPERATION

    Click here