WIRELESS CHARGING SYSTEM Status Signal Circuit

DESCRIPTION

This circuit sends a charging stop signal from the certification ECU (smart key ECU assembly) to the mobile wireless charger cradle assembly. Based on this signal, the wireless charging system stops the charging operation.

Tech Tips

The charging frequency of the wireless charging system overlaps with the electrical wave frequency band that is used when the entry and start system detects the position of the electrical key transmitter sub-assembly. Therefore, when the electrical key transmitter sub-assembly position is being detected, the charging stop signal from the certification ECU (smart key ECU assembly) makes the wireless charging system stop charging.

WIRING DIAGRAM

A01MJCLE18
*1 Certification ECU (Smart Key ECU Assembly)
*2 Mobile Wireless Charger Cradle Assembly

CAUTION / NOTICE / HINT

Note

Before replacing the certification ECU (smart key ECU assembly), refer to the service bulletin.

PROCEDURE


  1. CHECK MOBILE WIRELESS CHARGER CRADLE ASSEMBLY (DIS)


    1. A01MGCDC14
      *a

      Component with harness connected

      (Mobile Wireless Charger Cradle Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      e1-7 (L) - Body ground Within 5 seconds after turning power switch from off to on (ACC)*1 4.5 to 6.0 V
      When charging Below 1 V
      When charging is temporarily stopped by charging stop signal from certification ECU (smart key ECU assembly)*2 4.5 to 6.0 V
      *1: When the power switch is turned from off to on (ACC), the mobile wireless charger cradle assembly checks the charging stop signal for 5 seconds. If the charging stop signal is not 4 V or higher for 0.8 seconds or more within 5 seconds continuously, the mobile wireless charger cradle assembly determines that there is an open circuit in the charging stop signal circuit, blinks the indicator amber (pattern 1), and stops operation until the next time the power switch is turned on (ACC). For the indicator blinking patterns, Click here.
      *2: For the certification ECU (smart key ECU assembly) charging stop signal reception conditions, Click here.

      Tech Tips

      Check with the certification ECU (smart key ECU assembly) connector connected.

      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY - CERTIFICATION ECU [SMART KEY ECU ASSEMBLY])


    1. Disconnect the e1 mobile wireless charger cradle assembly connector.

    2. Disconnect the G39 certification ECU (smart key ECU assembly) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      e1-7 (L) - G39-21 (ASEL) Always Below 1 Ω
      e1-7 (L) or G39-21 (ASEL) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE SMART KEY ECU ASSEMBLY

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR