WIRELESS CHARGING SYSTEM Wireless Charger Illumination Circuit

DESCRIPTION

When the light control switch is turned to the TAIL or HEAD position, this circuit sends an illumination signal to the mobile wireless charger cradle assembly.

WIRING DIAGRAM

A01MIAVE10
*1 from TAIL Relay
*2 PANEL
*3 Mobile Wireless Charger Cradle Assembly

CAUTION / NOTICE / HINT

Note


  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • Troubleshoot the wireless charging system after confirming that the lighting system is functioning properly.

    Click here

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)


    1. A01MHPFC16
      *a

      Front view of wire harness connector

      (to Mobile Wireless Charger Cradle Assembly)

      Disconnect the mobile wireless charger cradle assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      e1-10 (ILL+) - Body ground Headlight dimmer switch assembly set to TAIL or HEAD 11 to 14 V
      Headlight dimmer switch assembly off Below 1 V
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR