REAR SEAT INNER BELT ASSEMBLY INSPECTION

PROCEDURE

1. INSPECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH

   
   

   1. Check the resistance.

      
      
      1. 

         *a	Component without harness connected (Rear Seat 3 Point Type Belt Assembly LH)

         Measure the resistance according to the value(s) in the table below.

         Standard Resistance
         Tester Connection Switch Condition Specified Condition 1 - 2 Buckle without tag plate inserted Below 1 Ω Buckle with tag plate inserted 10 kΩ or higher

         If the result is not as specified, replace the rear seat 3 point type belt assembly LH.

2. INSPECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH

   
   

   1. Check the resistance.

      
      
      1. 

         *a	Component without harness connected (Rear Seat 3 Point Type Belt Assembly RH)

         Measure the resistance according to the value(s) in the table below.

         Standard Resistance
         Tester Connection Switch Condition Specified Condition 1 - 2 Buckle without tag plate inserted Below 1 Ω Buckle with tag plate inserted 10 kΩ or higher

         If the result is not as specified, replace the rear seat 3 point type belt assembly RH.