SEAT CUSHION HEATER(for Rear Side) INSPECTION

PROCEDURE


  1. INSPECT SEPARATE TYPE REAR SEAT CUSHION COVER (for LH Side)


    1. Check the resistance.


      1. A01MFRQC04
        *a

        Component without harness connected

        (Separate Type Rear Cushion Cover LH)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        1 - 2 Always (20 °C (68 °F)) 3.34 to 4.00 Ω
        2 - 3 Always (20 °C (68 °F)) 3.34 to 4.00 Ω

        If the specified condition is not met, replace the separate type rear seat cushion cover (for LH Side).

  2. INSPECT SEPARATE TYPE REAR SEAT CUSHION COVER (for RH Side)


    1. Check the resistance.


      1. A01MFRQC05
        *a

        Component without harness connected

        (Separate Type Rear Cushion Cover RH)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        1 - 2 Always (20 °C (68 °F)) 3.34 to 4.00 Ω
        2 - 3 Always (20 °C (68 °F)) 3.34 to 4.00 Ω

        If the specified condition is not met, replace the separate type rear seat cushion cover (for RH Side).