CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver and front passenger sides.
The procedure described below is for the driver side.
PROCEDURE
INSTALL FRONT SEATBACK HEATER (FRONT SEATBACK WITH COVER PAD)
Install front seatback protector.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Push in installation direction (1) shown in the illustration to temporarily install the front seatback heater assembly (front seatback with cover pad).
Push in the rear end of the front seatback heater assembly (front seatback with cover pad) in installation direction (2) shown in the illustration.
Install the front seatback cover bracket with the 2 nuts.
Note
When installing the bracket, check that the band is not twisted.
Install the bracket so that it encloses the front seat airbag assembly.
If the bracket is not securely installed, the front seat airbag assembly may not deploy correctly.
INSTALL FRONT SEAT HEADREST SUPPORT
INSTALL FRONT SEAT BACK BOARD SUB-ASSEMBLY
CONNECT FRONT SEAT WIRE
Engage the clamps to connect the front seat wire to the front seat airbag wire.
Engage the clamps to connect the front seat airbag wire.
Engage the clamp.
Connect the connector.
INSTALL FRONT SEAT WIRE RH (for Front Passenger Side)
Connect the 3 connectors.
Engage the clamps to install the front seat wire RH.
CONNECT FRONT SEAT BACK BOARD SUB-ASSEMBLY
INSTALL FRONT INNER SEAT CUSHION SHIELD
INSTALL FRONT SEAT CUSHION SHIELD
INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD
INSTALL FRONT SEAT LEG COVER
INSTALL FRONT SEAT ASSEMBLY