PRE-CRASH SAFETY SYSTEM CANCEL SWITCH INSPECTION

PROCEDURE


  1. INSPECT PRECRASH SYSTEM CANCEL SWITCH ASSEMBLY


    1. A01MJPMC02
      *a

      Component without harness connected

      (Precrash System Cancel Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified
      1 (ECU) - 2 (GND) Pressed Below 1 Ω
      1 (ECU) - 2 (GND) Not pressed 10 kΩ or higher

      • If the result is not as specified, replace the precrash system cancel switch assembly.