SIDE AIRBAG SENSOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL DOOR SIDE AIRBAG SENSOR


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:


      • B006JL1

        Wait at least 90 seconds after disconnecting the cable from negative (-) auxiliary battery terminal to disable the SRS system.

      • A0026EN

        If this procedure is performed without disconnecting the cable from negative (-) auxiliary battery terminal, the airbag may deploy even if an impact is applied only to the door side airbag sensor. Therefore, make sure that the cable from negative (-) auxiliary battery terminal is connected before performing this procedure.

    3. Before connecting the airbag connector, check that the position of the housing lock is correct as shown in the illustration.

      A0026KPC06
      *1 CPA - -
      *a Incorrect *b Correct

    4. Engage the guide and hold the door side airbag sensor in place.

    5. Install the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the door side airbag sensor has been dropped, replace it with a new one.

      • When installing the door side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Tighten the bolt while holding the door side airbag sensor because the door side airbag sensor guide is easily damaged.

    6. Connect the connector.

      A0026DDC29
      *1 Housing Lock *2 CPA
      *3 CPA Upper Part - -
      *a Connection is Compleated - -

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Do not push down the upper part of the CPA shown in the illustration when connecting the airbag connector.

      • While holding the CPA, be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard.)

    7. Check that there is no looseness in the installation parts of the door side airbag sensor.

  2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Connect the cable to the negative (-) auxiliary battery terminal.

      Click here

  4. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  5. INSPECT SRS WARNING LIGHT

    Click here

  6. FC STACK ASSEMBLY ON-VEHICLE INSPECTION

    Click here

    Tech Tips

    Perform an on-vehicle inspection of the FC stack assembly only if the vehicle has been subjected to a strong impact.