CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      
      

      • 

        Wait at least 90 seconds after disconnecting the cable from negative (-) auxiliary battery terminal to disable the SRS system.

      • 

        If this procedure is performed without disconnecting the cable from negative (-) auxiliary battery terminal, the airbag may deploy even if an impact is applied only to the airbag ECU assembly. Therefore, make sure that the cable from negative (-) auxiliary battery terminal is disconnected before performing this procedure.

   3. Install the airbag ECU assembly.

      Note

      If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag ECU assembly with a new one.

   4. Install the 3 bolts.

      Torque:

      17.5 N*m  { 178 kgf*cm, 13 ft.*lbf }

   5. 

      *1	Connector Lock Lever
      	Lock Direction

      Connect the airbag connector and push the connector lock to lock the airbag connector.

      Note

      Do not allow the water proof sheet to become pinched.

      

   6. Check that there is no looseness in the installation parts of the airbag ECU assembly.

2. INSTALL COOLER BLOWER ASSEMBLY

   Click here

3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   
   

   1. Connect the cable to the negative (-) auxiliary battery terminal.

      Click here

4. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

   Click here

5. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here

6. INSPECT SRS WARNING LIGHT

   Click here

7. FC STACK ASSEMBLY ON-VEHICLE INSPECTION

   Click here

   Tech Tips

   Perform an on-vehicle inspection of the FC stack assembly only if the vehicle has been subjected to a strong impact.