CENTER AIRBAG SENSOR ASSEMBLY ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to follow the correct removal and installation procedures of the airbag ECU assembly.

PROCEDURE


  1. INSPECT AIRBAG ECU ASSEMBLY (for Vehicle not Involved in Collision)


    1. Perform a diagnostic system check.

      Click here

  2. INSPECT AIRBAG ECU ASSEMBLY (Vehicle Involved in Collision and Airbag not Deployed)


    1. Perform a diagnostic system check.

      Click here

    2. Visually check for defects with the airbag ECU assembly installed on the vehicle.


      1. The defects are as follows:


        • Cracks on the sensor housing

        • Dents on the sensor housing

        • Chips on the sensor housing

        • Cracks or other damage to the connector

        • Peeling of the label

        OK
        No defects are found.

        Tech Tips

        If any of the defects is found, replace the airbag ECU assembly with a new one.

  3. INSPECT AIRBAG ECU ASSEMBLY (Vehicle Involved in Collision and Airbag is Deployed)


    1. Replace the airbag ECU assembly.

      Tech Tips

      The airbag ECU assembly should be replaced after any of the airbags has deployed, as it has been subjected to an impact.