FRONT SEAT SIDE AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is LH side.

PROCEDURE


  1. INSTALL FRONT SEAT AIRBAG ASSEMBLY

    Note


    • The nuts must not be reused.

    • Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.


    1. Install the front seat airbag assembly with 2 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }
    2. A0026IH

      Engage the clamps to connect the wire harness.

  2. INSTALL FRONT SEATBACK WITH COVER PAD

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Connect the cable to the negative (-) auxiliary battery terminal.

      Click here

  4. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  5. INSPECT SRS WARNING LIGHT

    Click here

  6. FC STACK ASSEMBLY ON-VEHICLE INSPECTION

    Click here

    Tech Tips

    Perform an on-vehicle inspection of the FC stack assembly only if the vehicle has been subjected to a strong impact.