DOOR COURTESY LIGHT BULB(for Rear Side) REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the LH and RH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE COURTESY LIGHT ASSEMBLY


    1. A01MH2GC03
      *A RH Side
      *B LH Side
      B000ZUW Protective Tape
      B006JFV Remove in this Direction (1)
      B006JHL Remove in this Direction (2)

      Apply protective tape as shown in the illustration.

    2. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and guide as shown in the illustration.

    3. Disconnect the connector to remove the courtesy light assembly.

  2. REMOVE COURTESY LIGHT BULB


    1. A01MG9EC05
      *1 Courtesy Light Housing
      *2 Courtesy Light Cover
      *a Protective Tape
      B006JFV Remove in this Direction

      Using a screwdriver with its tip wrapped in protective tape, disengage the claw.

    2. Remove the courtesy light housing with courtesy light cover as shown in the illustration.

    3. A01MH7EC06
      B006JFV Remove in this Direction

      Remove the courtesy light cover as shown in the illustration.

    4. A01MGYNC06
      B006JFV Remove in this Direction

      Remove the courtesy light bulb as shown in the illustration.

  3. INSTALL COURTESY LIGHT BULB


    1. A01MJTSC06
      B006JFV Install in this Direction

      Install the courtesy light bulb as shown in the illustration.

    2. A01MHOXC06
      B006JFV Install in this Direction

      Install the courtesy light cover as shown in the illustration.

    3. A01MGL3C05
      *1 Courtesy Light Housing
      *2 Courtesy Light Cover
      B006JFV Install in this Direction

      Engage the claw to install the courtesy light housing with courtesy light cover as shown in the illustration.

  4. INSTALL COURTESY LIGHT ASSEMBLY


    1. Connect the connector.

    2. A01MJ6UC04
      *A RH Side
      *B LH Side
      B000ZUW Protective Tape
      B006JFV Install in this Direction (1)
      B006JHL Install in this Direction (2)

      Engage the guide and claw to install the courtesy light assembly as shown in the illustration.

    3. Remove the protective tape.