| DTC Code | DTC Name |
|---|---|
| B279C | Theft Deterrent System Presence Detection |
DESCRIPTION
If a EV control ECU that is incompatible with the immobiliser system is installed, the EV control ECU stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B279C | Theft Deterrent System Presence Detection | A EV control ECU that is incompatible with the immobiliser system is installed. (1-trip detection logic*) | EV control ECU | - |
*: Only detected while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
|---|---|
| Hybrid control system cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B279C | - |
CAUTION / NOTICE / HINT
Note
When using the GTS with the power switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
Before replacing the EV control ECU refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."
PROCEDURE
REPLACE EV CONTROL ECU
Replace the EV control ECU with a new one.
| Result | ||
|---|---|---|
|
| NEXT |
|
END (EV CONTROL ECU WAS DEFECTIVE) |