REAR DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY


    1. A01MFSJ

      Engage the guide to install the rear door inside locking cable assembly to the rear door lock assembly.

  2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY


    1. A01MJL4

      Engage the guide to install the rear door lock remote control cable assembly to the rear door lock assembly.

  3. INSTALL REAR DOOR LOCK COVER SUB-ASSEMBLY


    1. A01MI6S

      Engage the guides to install the rear door lock cover sub-assembly to the rear door lock assembly.

    2. A01MFPCC01
      B006JFV Install in this Direction

      Engage the claws as shown in the illustration.

  4. INSTALL REAR DOOR LOCK ASSEMBLY

    Note


    • When reusing a removed rear door lock assembly, replace the door lock wire harness seal with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

    • Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the rear door lock assembly.


    1. Apply MP grease to the sliding parts of the rear door lock assembly.

    2. When reusing the rear door lock assembly:


      1. Install a new door lock wiring harness seal to the rear door lock assembly.

    3. A01MIQEC01
      *1 Release plate
      B006JFV Install in this Direction

      Connect the release plate as shown in the illustration.

      Tech Tips

      Make sure that the release plate is securely connected to the rear door lock assembly.

    4. Using a T30 "TORX" socket wrench, install the rear door lock assembly with the 3 screws.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    5. Connect the connector.

  5. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  6. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  7. INSTALL REAR DOOR GLASS RUN

    Click here

  8. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  9. INSTALL REAR DOOR GLASS INNER WEATHERSTRIP

    Click here

  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  11. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  12. INSTALL NO. 1 REAR DOOR STIFFENER CUSHION

    Click here

  13. INSTALL REAR DOOR ARMREST COVER

    Click here

  14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  15. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  16. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  17. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  18. INSPECT POWER WINDOW OPERATION

    Click here