FRONT DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY


    1. A01MJSM

      Engage the guide to install the front door inside locking cable assembly to the front door with motor lock assembly.

  2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY


    1. A01MIUF

      Engage the guide to install the front door lock remote control cable assembly to the front door with motor lock assembly.

  3. INSTALL FRONT DOOR LOCK COVER SUB-ASSEMBLY


    1. A01MIZW

      Engage the guides to install the front door lock cover sub-assembly to the front door with motor lock assembly.

    2. A01MJ21C01
      B006JFV Install in this Direction

      Engage the claws as shown in the illustration.

  4. INSTALL FRONT DOOR WITH MOTOR LOCK ASSEMBLY

    Note


    • When reusing a removed front door with motor lock assembly, replace the door lock wire harness seal with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

    • Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the front door with motor lock assembly.


    1. Apply MP grease to the sliding parts of the front door with motor lock assembly.

    2. When reusing the front door with motor lock assembly:


      1. Install a new door lock wiring harness seal to the front door with motor lock assembly.

    3. A01MGYBC01
      *1 Front Door Lock Open Rod
      B006JFV Install in this Direction

      Connect the front door lock open rod as shown in the illustration.

      Tech Tips

      Make sure that the front door lock open rod is securely connected to the front door with motor lock assembly.

    4. Using a T30 "TORX" socket wrench, install the front door with motor lock assembly with the 3 screws.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    5. Connect the connector.

  5. INSTALL FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)

    Click here

  6. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  7. INSTALL FRONT DOOR GLASS RUN

    Click here

  8. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  9. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  10. INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

    Click here

  11. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  12. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  13. INSTALL NO. 1 FRONT DOOR STIFFENER CUSHION

    Click here

  14. INSTALL FRONT DOOR ARMREST COVER

    Click here

  15. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  16. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  17. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  18. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  19. INSPECT POWER WINDOW OPERATION

    Click here