BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1ABB

DTC Code DTC Name
C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.

Tech Tips

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete A beam axis inspection has not been performed. Blind spot monitor sensor RH Stored when a blind spot monitor sensor is replaced.

PROCEDURE


  1. PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)


    1. Change the blind spot monitor sensor RH to Test Mode using the GTS.


      Body Electrical > Blind Spot Monitor Master > Utility
      Tester Display
      BSM Master Beam Axis Inspection

      Tech Tips

      Refer to Blind Spot Monitor Beam Axis Inspection.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    END