BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1ABC

DTC Code DTC Name
C1ABC Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.

Tech Tips

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C1ABC Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete A beam axis inspection has not been performed. Blind spot monitor sensor LH Stored when a blind spot monitor sensor is replaced.

PROCEDURE


  1. PROCEED TO TEST MODE


    1. Change the blind spot monitor sensor LH to Test Mode using the GTS.


      Body Electrical > Blind Spot Monitor Slave > Utility
      Tester Display
      BSM Slave Beam Axis Inspection

      Tech Tips

      Refer to Blind Spot Monitor Beam Axis Inspection.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    END