NOISE FILTER INSTALLATION

PROCEDURE


  1. INSTALL RADIO SETTING CONDENSER (for High Mounted Stop Light)


    1. B006JKK

      Engage the claw to install a new terminal cover to the wire harness.

      Note


      • Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

      • Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

      • Do not use excessive force when inserting the wire harness into the terminal cover.

      • If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.

    2. B006JLP

      Engage the 6 claws to install the 2 new terminal covers with wire harness to a new radio setting condenser condenser.

      Note


      • Do not use excessive force when inserting the terminal covers into the condenser.

      • If a terminal cover has been deformed during installation, replace the terminal, terminal covers and radio setting condenser with new ones.

    3. B006JHQ

      Insert the cover as shown in the illustration and engage the claw.

    4. B006JIR

      Engage the clamp to temporarily install the new radio setting condenser with wire harness.

    5. Install the radio setting condenser with the bolt.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

  2. INSTALL NO. 1 EV BATTERY INTAKE DUCT

    Click here

  3. INSTALL RADIO SETTING CONDENSER (for Window Defogger)


    1. B006JKK

      Install the claw to install a new terminal cover to the wire harness.

      Note


      • Make sure to hold the wire harness so that the crimping side of the terminal is facing up when installing the wire harness to the terminal cover.

      • Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

      • Do not use excessive force when inserting the wire harness into the terminal cover.

      • If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.

    2. B006JEZC01
      B006JFV Install in this Direction

      Engage the claws to install the terminal cover with wire harness to a new condenser as shown in the illustration.

      Note


      • Do not use excessive force when inserting the terminal cover into the condenser.

      • If the terminal cover has been deformed at installation, replace the terminal, cover and condenser with new ones.

    3. B006JL9

      Engage the clamp to temporarily install the radio setting condenser with wire harness.

    4. Install the radio setting condenser with the bolt.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

  4. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here