STEERING GEAR COMPONENTS
ILLUSTRATION
| *1 | FRONT FLOOR COVER LH | *2 | FRONT FLOOR COVER RH |
ILLUSTRATION
| *1 | REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH | *2 | REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY LH |
| *3 | FRONT LOWER BUMPER ABSORBER | *4 | NO. 1 MOTOR UNDER COVER |
| *5 | NO. 2 MOTOR UNDER COVER | *6 | REAR MOTOR UNDER COVER LH |
| *7 | REAR MOTOR UNDER COVER RH | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | COLUMN HOLE COVER SILENCER SHEET | *2 | NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
| *3 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY | *4 | FRONT SUSPENSION MEMBER REAR BRACE LH |
| *5 | FRONT SUSPENSION MEMBER REAR BRACE RH | *6 | FRONT STABILIZER LINK ASSEMBLY LH |
| *7 | FRONT STABILIZER LINK ASSEMBLY RH | *8 | REAR MOTOR MOUNTING INSULATOR |
| *9 | FRONT NO. 1 SUSPENSION LOWER ARM SUB-ASSEMBLY LH | *10 | FRONT NO. 1 SUSPENSION LOWER ARM SUB-ASSEMBLY RH |
| *11 | COTTER PIN | - | - |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| * | For use with ball joint lock nut wrench | ● | Non-reusable part |
ILLUSTRATION
| *1 | STEERING LINK ASSEMBLY | *2 | STEERING INTERMEDIATE SHAFT |
| *3 | NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY | *4 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *1 | STEERING GEAR ASSEMBLY | *2 | TIE ROD END SUB-ASSEMBLY LH |
| *3 | TIE ROD END SUB-ASSEMBLY RH | - | - |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *1 | NO. 1 STEERING RACK BOOT | *2 | NO. 2 STEERING RACK BOOT |
| *3 | STEERING RACK BOOT CLAMP | *4 | STEERING RACK BOOT CLIP |
| *5 | STEERING GEAR ASSEMBLY | - | - |
| ● | Non-reusable part |  |
Lithium soap base glycol grease |