PARKING BRAKE SWITCH INSPECTION

PROCEDURE


  1. INSPECT PARKING BRAKE SWITCH ASSEMBLY


    1. A01MGEKC11
      *a

      Component without harness connected

      (Parking Brake Switch Assembly)
      *b Terminal
      *c Switch body
      *d On
      *e Off

      Check the resistance.


      1. Measure the resistance between the connector terminal and the nut inside the parking brake switch assembly.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        Terminal - Switch body

        Parking brake switch on

        (Switch pin free)

        		 Below 1 Ω

        Parking brake switch off

        (Switch pin pushed in)

        		 10 kΩ or higher

        If the value is not as specified, replace the parking brake switch assembly.