REAR BRAKE REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG


    1. Install the rear disc brake bleeder plug to the rear disc brake cylinder assembly.

      Tech Tips

      Fully tighten the rear disc brake bleeder plug after bleeding the system.

  2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP


    1. Install the rear disc brake bleeder plug cap to the rear disc brake bleeder plug.

  3. INSTALL PISTON SEAL


    1. A01MIORC02
      B000ZUW Lithium Soap Base Glycol Grease

      Apply lithium soap base glycol grease to the entire circumference of a new piston seal.

    2. A01MJ1XC02
      *1 Piston Seal
      *2 Rear Disc Brake Cylinder Assembly

      Install the piston seal to the rear disc brake cylinder assembly.

      Note

      Securely install the piston seal to the groove of the rear disc brake cylinder assembly.

  4. INSTALL REAR DISC BRAKE PISTON


    1. A01MGVXC03
      *1 Cylinder Boot
      *2 Rear Disc Brake Piston
      B000ZUW Lithium Soap Base Glycol Grease

      Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.

    2. Install the cylinder boot to the rear disc brake piston.

    3. Apply a light layer of lithium soap base glycol grease to the contact surfaces of the rear disc brake piston, and install it to the rear disc brake cylinder assembly.

      Note

      Do not forcibly install the rear disc brake piston into the rear disc brake cylinder assembly.

  5. INSTALL CYLINDER BOOT


    1. A01MGE8C01

      Install the cylinder boot to the rear disc brake cylinder assembly.

      Note


      • Do not damage the cylinder boot.

      • Securely install the cylinder boot into the groove of the rear disc brake cylinder assembly and groove of the rear disc brake piston.