| DTC Code | DTC Name |
|---|---|
| C1521/24 | Short in Motor Circuit |
| C1531/25 | ECU Malfunction |
| C1532/25 | ECU Malfunction |
| C1533/25 | Temperature Sensor Circuit is Low or High |
| C1534/25 | EEPROM Malfunction |
| C1554/23 | Power Supply Relay Failure |
DESCRIPTION
The power steering ECU assembly detects steering force using the signal received from the steering torque sensor, and also monitors the motor circuit for errors.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1521/24 | Short in Motor Circuit | Motor overcurrent | Power steering ECU assembly | On | Power switch on (IG) again | - |
| C1531/25 | ECU Malfunction | ECU internal malfunction (CPU malfunction) |
Power steering ECU assembly | On | Power switch on (IG) again | - |
| C1532/25 | ECU Malfunction | ECU internal malfunction (Peripheral circuit malfunction) |
Power steering ECU assembly | On | Power switch on (IG) again | - |
| C1533/25 | Temperature Sensor Circuit is Low or High | ECU internal malfunction (Substrate temperature sensor malfunction) |
Power steering ECU assembly | Off | After normal confirmation | - |
| C1534/25 | EEPROM Malfunction | ECU internal malfunction (EEPROM error) |
Power steering ECU assembly | Torque sensor zero point adjustment is set to the default value and control is continued. In this case, the warning light illuminates. | Power switch on (IG) again | - |
| C1554/23 | Power Supply Relay Failure | Power source relay circuit malfunction |
|
On | Power switch on (IG) again | - |
CAUTION / NOTICE / HINT
Note
If the power steering ECU assembly has been replaced, perform assist map writing, rotation angle sensor value initialization and torque sensor zero point calibration.
PROCEDURE
CHECK FOR DTC
Clear the DTCs.
Check for DTCs.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| A |
|
REPLACE POWER STEERING ECU ASSEMBLY Click here |
| B |
|
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS Click here |