STEERING ANGLE SENSOR REMOVAL

CAUTION / NOTICE / HINT

CAUTION / NOTICE / HINT

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here

PROCEDURE

1. REMOVE STEERING WHEEL ASSEMBLY

   Click here

2. REMOVE LOWER STEERING COLUMN COVER

   Click here

3. SEPARATE METER HOOD SPACER

   Click here

4. REMOVE UPPER STEERING COLUMN COVER

   Click here

5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

6. INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

   Click here

7. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

   Note

   
   

   • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

   • Do not rotate the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

   • When rotating the spiral cable with sensor sub-assembly to check the operation of the sensor (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel assembly installed.

   
   

   1. 

      *1

      Slider

      Slide the airbag connector slider as shown in the illustration and disconnect the airbag connector from the spiral cable sub-assembly with sensor.

   2. Disconnect each connector from the spiral cable with sensor sub-assembly.

   3. 

      Remove in this Direction

      Disengage the 3 claws and remove the spiral cable with sensor sub-assembly as shown in the illustration.