STEERING ANGLE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to read Precaution thoroughly before servicing.

A0026SW

Click here

PROCEDURE


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  3. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

    • Do not rotate the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

    • When rotating the steering angle sensor to check the operation of the sensor (checking for abnormal noise, performing diagnostics, etc.), make sure that the front wheels are aligned straight ahead and the steering wheel is installed.


    1. Turn the power switch off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:


      • Do not begin this procedure within 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal.

      • If something causes the airbag to deploy, it could result in a serious accident possibly resulting in death.

      A0026P6

    3. Set the turn signal switch to the neutral position.

      Note

      If it is not in the neutral position, the turn signal switch pin may snap.

    4. A01MGR2C02
      B006JFV Install in this Direction

      Engage the 3 claws to install the spiral cable with sensor sub-assembly.

    5. Connect each connector to the spiral cable with sensor sub-assembly.

    6. A01MGE3C03
      *1 Slider
      *a Lock Position

      Connect the airbag connector to the spiral cable with sensor sub-assembly.

    7. Check that the slider is in the lock position.

      Tech Tips

      If the slider is not in the lock position, the airbag connector is not completely connected. Disconnect the airbag connector, check the airbag connector and spiral cable with sensor sub-assembly terminals and connector housings for deformation or foreign matter, and then reconnect the airbag connector.

  4. INSTALL UPPER STEERING COLUMN COVER

    Click here

  5. INSTALL METER HOOD SPACER

    Click here

  6. INSTALL LOWER STEERING COLUMN COVER

    Click here

  7. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  8. INSTALL STEERING WHEEL ASSEMBLY

    Click here