REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • The rear speed sensor rotor is a component of the rear axle hub and bearing assembly. If the rear speed sensor rotor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. INSTALL SKID CONTROL SENSOR WIRE


    1. Install the 2 grommets of the skid control sensor wire to the rear axle beam assembly.

      Note

      Do not twist the skid control sensor wire harness when installing it.

    2. A01MJ1WE03

      Install the 2 sensor clamps to the side member and rear axle beam assembly with the 2 nuts.

      Torque:
      for Bolt A
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
      for Bolt B
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the skid control sensor wire harness when installing it.

    3. A01MFP9C08
      *1 Grommet
      *2 Connector
      *3 Band Clamp
      *a Inside of Vehicle

      Insert the connector and grommet of skid control sensor wire into the inside of the vehicle body through the hole in the wheel house.

      Note

      Make sure the band clamp remains on the outside of the vehicle.

    4. Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.

      A01MFJHC04
      *a Outside of Vehicle *b 30°

      Note


      • When pulling out the grommet, do not grip the skid control sensor wire .

      • Fix the grommet in place within the range shown in the illustration.

    5. Connect the connector.

  2. INSTALL NO. 1 EV BATTERY INTAKE DUCT

    Click here

  3. INSTALL REAR SEAT ASSEMBLY

    Click here

  4. INSTALL REAR WHEEL HOUSE LINER


    1. Install the rear wheel house liner with the 2 clips.

  5. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    1. Install the rear axle hub and bearing assembly to the rear axle beam assembly with the 4 bolts.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

      Tech Tips


      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

  6. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  7. INSPECT REAR AXLE HUB RUNOUT

    Click here

  8. INSTALL REAR DISC

    Click here

  9. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

    Click here

  10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  11. CONNECT SKID CONTROL SENSOR WIRE


    1. Connect the skid control sensor wire connector to the rear axle hub and bearing assembly.

  12. ADJUST PARKING BRAKE

    Click here

  13. INSTALL REAR WHEEL

    Click here

  14. CHECK FOR SPEED SENSOR SIGNAL

    Click here