REAR SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • The rear speed sensor rotor is a component of the rear axle hub and bearing assembly. If the rear speed sensor rotor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. SEPARATE SKID CONTROL SENSOR WIRE


    1. A01MHRZC02
      *a Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, disconnect the skid control sensor wire connector.

      Note

      Be careful not to damage the rear axle hub and bearing assembly and connector cover.

  3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  4. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

    Click here

  5. REMOVE REAR DISC

    Click here

  6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. A01MJ95

      Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle beam assembly.

      Tech Tips


      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

  7. SEPARATE REAR WHEEL HOUSE LINER

    A01MIOF

    1. Remove the 2 clips and separate the rear wheel house liner.

  8. REMOVE REAR SEAT ASSEMBLY

    Click here

  9. REMOVE NO. 1 EV BATTERY INTAKE DUCT

    Click here

  10. REMOVE SKID CONTROL SENSOR WIRE


    1. A01MIWT

      Disconnect the connector.

    2. Disconnect the grommet of the rear skid control sensor wire from the hole of the wheel house.

    3. A01MJ1W

      Remove the 2 nuts to separate the 2 sensor clamps from the side member and rear axle beam assembly.

    4. A01MIDN

      Remove the 2 grommets of the skid control sensor wire from the rear axle beam assembly.