FRONT SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • The front speed sensor rotor is a component of the front axle hub sub-assembly. If the front speed sensor rotor is malfunctioning, replace the front axle hub sub-assembly.

PROCEDURE


  1. REMOVE FRONT WHEEL

    Click here

  2. SEPARATE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY


    1. A01MIXM

      Using a 4 mm hexagon socket wrench, remove the 2 hexagon screws.

    2. Remove the 4 screws and 3 clips.

    3. A01MHCQ

      Remove the grommet to separate the front fender splash shield sub-assembly from the vehicle body.

  3. REMOVE FRONT SPEED SENSOR


    1. Turn back the front fender splash shield sub-assembly.

    2. A01MJR0

      Disconnect the connector.

    3. Disengage the 2 clamps to separate the front speed sensor from the vehicle body.

    4. A01MIBJ

      Remove the 2 bolts to separate the front speed sensor clamp from the front shock absorber assembly and vehicle body.

    5. A01MGFM

      Disengage the clamp from the front shock absorber assembly.

    6. Remove the bolt and front speed sensor from the steering knuckle.

      Note

      Prevent foreign matter from adhering to the front speed sensor tip.