BRAKE PEDAL(for RHD) ADJUSTMENT

PROCEDURE


  1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT

    Note

    Inspect and adjust the brake pedal height with the floor carpet turn back.


    1. Check the brake pedal height.

      A01MIG9C02
      *1 Brake Pedal *2 Clevis Lock Nut
      *a Brake Pedal Height *b Measuring Plane of Floor Panel
      Brake pedal height from floor panel
      138.9 to 148.9 mm (5.47 to 5.86 in.)

    2. Adjust the brake pedal height.


      1. Remove the stop light switch assembly.

        Click here

      2. Loosen the clevis lock nut.

      3. Adjust the brake pedal height by turning the push rod.

        Brake pedal height from floor panel
        138.9 to 148.9 mm (5.47 to 5.86 in.)

      4. Tighten the clevis lock nut.

        Torque:
        25.5 N*m  { 260 kgf*cm, 19 ft.*lbf }

      5. Install the stop light switch assembly.

        Click here

  2. INSPECT AND ADJUST BRAKE PEDAL STROKE SENSOR ASSEMBLY

    Click here

  3. INSPECT BRAKE PEDAL FREE PLAY


    1. A01MI84C19
      *a Brake Pedal Free Play

      Depress the brake pedal until a slight resistance is felt. Measure the brake pedal free play as shown in the illustration.

      Brake pedal free play
      1.0 to 6.0 mm (0.0394 to 0.236 in.)

      If the pedal free play is not as specified, check the stop light switch clearance.

      Click here

      If the pedal free play is as specified, proceed to the Inspect Brake Pedal Reserve Distance procedure.

  4. INSPECT BRAKE PEDAL RESERVE DISTANCE


    1. With the power switch on (READY), depress the brake pedal and measure the pedal reserve distance.

      Brake pedal reserve distance from floor panel at 196 N (20 kgf, 44 lbf)
      More than 84 mm (3.31 in.)

      Note


      • Check the brake pedal reserve distance at the same location as that used when checking the brake pedal height.

      • Inspect and adjust the brake pedal height with the floor carpet turn back.

  5. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE

    Click here